Posts Tagged ‘bumper’
Semi Trailer bumpers are becoming more technologically advanced in an effort to reduce the likelihood of severe injury or death in the event of a rear-end collision. The Insurance Institute of Highway Safety, IIHS, has tested new semi bumpers and determined that new designs are performing much better than previous iterations used on older trailers. The trailer bumpers, known in the industry as ICC bumpers (after the Interstate Commerce Commission) or simply as underride guards, are put in place to protect passenger vehicles against the high-slung blunt edges of a trailer in the event that a passenger vehicle collides with the rear of the trailer. Typically, trailer decks on semi trailers sit at a height of about 48 inches, whereas a typical passenger vehicle’s front clip sits much lower than this. In some cases, the entire front of a passenger car can fit underneath a trailer deck, positioning the deck edge at a point where the vehicle’s occupants’ heads could be decapitated in the event of an accident.
The IIHS has undertaken testing of trailer ICC bars from trailer manufacturers such as Great Dane, Manac, Stoughton, Vanguard, Wabash, Hyundai Translead, Strick, and Utility to find out how new ICC bar configurations fare against three distinct rear-end collision tests. The first test is directed at the full width of the ICC bar, impacted by a vehicle traveling 35 mph. The second test focuses at approximately 50 percent of the width of the ICC bar, again at 35 mph. The third test focuses the impacting vehicle at only the edge of the ICC bar to determine how well it sustains an offset collision.
Despite the improvements in ICC bar technology, government statistics show that commercial vehicle versus passenger vehicle accidents are still on the rise. Even worse, the number of fatalities caused by commercial vehicle crashes has increased between 2011 and 2015 by over 39 percent.
Taken from www.motor1.com